Skip to content
Axionics

Machining

Real parts, real programs.

Choose a part. First you see what AXIONICS does in the software, then the tool following the generated program line by line. Drag to rotate.

Material-removal simulation rebuilt from the program, not footage of the machine. Time is sped up. Part numbers and title blocks have been removed.

The three parts, in short

1

Fixture plate in POM

423.6 × 237 × 28 mm, 3-axis machining centre, first of two setups, in a vise. AXIONICS recognised 98 seats with through holes, the outer contour and the chamfers, chose four tools from the in-house catalogue and prepared eight operations: facing, contouring, pockets, chamfers and drilling. The program has over 56,000 lines.

2

Flange in PTFE

115 × 82 × 8 mm, 3-axis CNC router, single setup, in a vise. A 35 mm hole, two pilot holes for G 1/4 threads and an 8 mm hole with chamfer. AXIONICS prepared ten operations on the machine and flagged the two to be done by hand to the technician. The first program was rejected by the automatic check, the second was verified.

3

Small block in PEEK

32 × 15 × 11.5 mm, 3-axis CNC router, single setup, on a vacuum table. Two 4.5 mm holes with an 8.5 mm counterbore and an edge chamfer. AXIONICS prepared twelve operations with three tools. The check found a toolpath cutting into the part: the program was rejected and corrected before reaching the technician.

Let's see it on your parts.

Request a demo